Publicité
Disposal
Disposal
GB
Packaging materials
The packaging materials are environ-
mentally friendly and can be recycled.
The plastic components are identifi ed by
markings, e.g. >PE<, >PS<, etc.
Please dispose the packaging materials
in the appropriate container at the
community waste disposal facilities.
Troubleshooting
GB
Problem
Soleplate is not heating even though iron is
turned on.
Iron does not produce steam.
Spray function does not work.
Steam jet and vertical steam jet function does
not work.
Water leaks from the soleplate during ironing.
Flakes and impurities come out of the
soleplate during ironing.
Water leaks from the soleplate while the iron is
cooling down or after it has been stored.
AEG IFU 5Safety Mahe 19.07.11.indd 19
Old appliance
The symbol
on the product or on
its packaging indicates that this product
may not be treated as household waste.
Instead it shall be handed over to the
applicable collection point for the
recycling of electrical and electronic
equipment. By ensuring this product
is disposed of correctly, you will help
prevent potential negative consequences
Possible cause
Connection problem
Temperature control is in MIN position.
Not enough water in tank.
Steam control is selected in non-steam position.
Not enough water in tank.
Steam jet function was used very frequently
within a short period.
Iron is not hot enough.
The iron is not hot enough.
You have used hard water, which has caused
scale fl akes to develop in the water tank.
The iron has been put in horizontal position
while there is still water in the water tank.
for the environment and human health,
which could otherwise be caused by
inappropriate waste handling of this
product. For more detailed information
about recycling of this product, please
contact your local city offi ce, your
household waste disposal service or the
shop where you purchased the product.
Solution
Check main power supply cable, plug and
outlet.
Select adequate temperature.
Fill water tank (see "Getting started", no 2).
Set steam control between positions of
minimum steam and maximum steam (see
"Ironing chart").
Fill water tank (see "Getting started", no 2).
Put iron on horizontal position and wait
before using steam jet function.
Adjust the proper temperature to steam
ironing (up to
). Put iron in vertical
position and wait until temperature indicator
light turns off .
Set the temperature dial to a temperature
(
to maximum) suitable for steam ironing.
Put the iron on its heel and wait until the light
has gone out before you start ironing.
Use the self-clean function one or more times.
Empty the water tank and set the steam
control to position off before storing the iron.
D
EL
NL
F
GB
19
19.07.11 11:19
Publicité
