Yamaha RS Venture RST90GTY 2009 Mode D'emploi page 146

Fault code No. 44
Diagnostic No. d:60 (EEPROM improper cylinder indication)
Order Item/components and probable cause
1 Malfunction in ECU.
Fault code No. 46
Diagnostic code No. – –
Order Item/components and probable cause
1 Connections
• Wire harness ECU coupler
2 Faulty battery.
3 Malfunction in rectifier/regulator.
4 Open or short circuit in wire harness.
Fault code No. 50
Diagnostic code No. – –
Order Item/components and probable cause
1 Malfunction in ECU.
FUEL INJECTION SYSTEM
Error is detected while reading or writing on EEPROM (CO adjustment
Symptom
value).
Check or maintenance job
Execute the diagnostic mode (code No. d:60).
1. Check the faulty cylinder. (If multiple cylinders
are defective, the display alternates every 2
seconds.)
2. Readjust the CO of the displayed cylinder.
Replace ECU if defective.
Symptom Power supply to the ECU is not normal.
Check or maintenance job
Check the coupler for any pins that may have
pulled out.
Check the locking condition of the coupler.
If there is a malfunction, repair it and connect the
coupler securely.
Replace or charge the battery.
Refer to "BATTERY INSPECTION" in CHAPTER
2.
Replace if defective.
Refer to "CHARGING SYSTEM" in CHAPTER 8.
Repair or replace if there is an open or short cir-
cuit.
Between the battery and main fuse coupler.
Red – Red
Between the main fuse coupler and fuse box ter-
minal (ignition fuse).
Red – Red
Between the fuse box terminal (ignition fuse) and
main switch coupler.
Red/Yellow – Red/Yellow
Between the main switch coupler and engine stop
switch coupler.
Brown – Brown
Between the engine stop switch coupler and ECU
coupler.
Red/White – Red/White
Faulty ECU memory. (When this malfunction is detected in the ECU, the
Symptom
fault code number might not appear on the meter.)
Check or maintenance job
Replace the ECU.
68
FI
Reinstatement
method
Setting the
engine stop
switch to "RUN"
and turning the
main switch on.
Reinstatement
method
Starting the
engine and
operating it at
idle.
Reinstatement
method
Setting the
engine stop
switch to "RUN"
and turning the
main switch on.