PNI ESCORT HP 8900 Manuel Utilisateur page 4

terminals, internal components that are not covered by the warranty.
There are no components of the radio that can be repaired by the user. For
repairs, contact an authorized service center.
To prevent the risk of fire, use a suitable power supply.
Installation instructions
Before installing the radio in your car, choose the most suitable location so
that when using it, it does not disturb you while driving.
To install the radio, use the bracket and accessories in the package. The
screws must be tightened well to avoid vibration of the radio while driving.
The mounting bracket can be positioned above or below the radio, and it can
be tilted depending on the installation method.
Power the radio
The power cable of the radio includes a protection fuse, installed in the
cigarette lighter socket. To power the radio, insert the cigarette lighter plug
into the dedicated slot under your car's dashboard.
WARNINGS
Make sure that you power the radio at 12V/24V.
If the fuse burns, do not replace it with a higher value one. The one in the factory
has 2A.
The installation of the antenna
To use the radio you need an antenna that operates in the frequency range
26-28MHz.
To install and calibrate the antenna, consult a specialized technician.
Usually, the antenna must be positioned on the highest part of the vehicle,
without being shielded by obstacles and as far as possible from any electrical
source or electromagnetic noise. The coaxial cable of the antenna must not be
interrupted or pressed. Connect the plug on the end of the antenna coaxial
cable to the antenna plug on the back of the radio.
User manual 4