Maintenance And Cleaning; Installing A Prewound Reel - Alpina ETR 750 Manuel D'utilisation

ETR 750 - ETR 900J
9. M
AINTENANCE AND CLEANING
I
NSTALLING A NEW TRIMMING LINE
The trimming line may be replaced by two methods
- rewinding the existing reel or installing a
prewound reel.
Rewinding the existing reel
To rewind the existing reel you must:
Check for the correct line size.
Remove the inner reel and spring.
Wind the reel with the new line.
Reinstall the existing reel and spring.
Cutting cord
Use a reel with a double square twisted cutting
cord of the same dimensions as the cord supplied
with the appliance.
Removing the existing reel
F . 7
IG
Unscrew the Bump Knob counterclockwise (A).
Remove the inner reel (B).
Use a clean cloth to clean the inside of the outer
spool (C).
Check the indexing teeth on the reel and spool
for wear (D). If necessary, replace the reel and
spool.
Winding the existing reel
F . 8
IG
Insert the ends of new trimming line into the in-
ner reel holes (A).
Loop the line into two equal lengths before in-
serting it into the holes.
Wind the line, in even and tight layers (B), onto
the reel, and in the direction indicated.
Push the ends of the line into the slots (C).
Reinstalling the reel
F . 9
IG
Insert the ends of the line through the eyelets in
the outer spool (A).
Grasp the ends and pull firmly to release the line
from the slots in the spool.
Install the Bump Knob clockwise (B).
Line installation is now complete.
I
NSTALLING A PREWOUND REEL
Use the same instructions as the existing reel:
The correct line to use;
Removing the existing reel;
Reinstalling the reel.
C
LEANING
Before cleaning, always switch off the motor
and disconnect the cable from the socket.
Never wash the machine.
Use just a dry or slightly damp cloth to clean the
rest of the machine. Do not use solvents or
abrasive cleaning agents. Before reconnecting
the appliance to the power supply, make sure
the motor casing and internal components are
not damp.
16
02_inglese.p65
S
TOPPING AND STORAGE
If you do not plan to use the machine for a long
period, perform the following operations in order
to keep it in good condition and ensure you can
start working again later easily and efficiently.
Clean the machine with a damp cloth or a soft
brush.
Put it back in its original box.
ATTENTION: Never wash the machine. Keep it out of
reach of children.
16 09/01/2006, 17.00