Viking MB 2 R Manuel D'utilisation page 42

Blade fastening screw
9008 319 9028
Retaining washer
0000 702 6600
The fastening elements for the
mowing blade (e.g. blade fastening
screw, retaining washer) must be
renewed when replacing the blade,
i.e. when installing the blade. Spare
parts are available from a VIKING
specialist dealer.
16. Service schedule
16.1 Handover confirmation
40
16.2 Service confirmation
Please hand this instruction manual
to your VIKING specialist dealer in
the case of maintenance work.
He will confirm the service operations
performed in the pre-printed boxes.
Service performed on
Next service date
17. Minimising wear and
preventing damage
Important information on maintenance
and care of the product group
Petrol lawn mowers
VIKING assumes no liability for material or
personal damage caused by the non-
observance of information contained in the
operating instructions, in particular with
regard to safety, operation and
maintenance, or which arise through the
use of unauthorised attachment or spare
parts.
Please always observe the following
important information for the prevention of
damage or excessive wear to your VIKING
machine:
1. Wearing parts
Some parts of the VIKING machine are
subject to normal wear even when used
properly and must be replaced in due time
depending on type and duration of use.
These include:
– Mowing blade
– V-belt (MB 2 RT)
– Tyres
2. Compliance with the information in
this instruction manual
17 The VIKING machine must be used,
maintained and stored with the care
described in this instruction manual. Any
damage caused by non-compliance with
the safety, operating and maintenance
instructions is the sole responsibility of the
user.
This applies in particular to:
– Product modifications not approved by
VIKING.
– Use of fuel and lubricants not approved
by VIKING (lubricants, petrol and
engine oil, see engine manufacturer's
specifications).
– The use of tools or accessories which
are not approved or suitable for the
machine, or are of inferior quality.
– Improper use of the product.
– Use of the product for sporting or
competitive events.
– Resultant damage due to continued use
of the product with defective
components.
3. Maintenance operations
All operations listed in the section
"Maintenance" must be performed
regularly.
If these maintenance operations cannot be
carried out by the user, a specialist dealer
must be commissioned to perform them.
VIKING recommends that you have
maintenance operations and repairs
performed exclusively by a VIKING
specialist dealer.
VIKING specialist dealers regularly attend
training courses and are provided with
technical information.
0478 111 9926 C - EN