Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
3.0
3.1
HANDLE AND WHEELS ASSEMBLY (fIG. 1-2)
FIG. 1
FIG. 1
•
Unpack the welder;
•
Screw the two casters (D) to the machine;
•
nsert the axle (A) through the holes at the rear of the welder and slide a wheel (B) on to each end
followed by the retaining washers (C);
•
Assemble the plastic handle (E) using the screws provided (F);
FIG. 2
GENERATOR
•
Insert the axle (B) through the holes at the rear of the welder, slide the washers (D) and the wheels
(A) as shown in picture 2 and fix the wheels (A) using the supplied rings;
•
Mount the handle (E) on the supports (F) e fix the together with the spacers (H) to the front panel
using the provided screws (G);
SEPARATE WIRE FEEDER
•
Mount the handle (L) on the supports (M) and fix them using the provided screws (N);
•
Screw the four casters (I) to the wire feeder bottom;
•
Assemble the rotating support (O) on the top of the generator using the provided washers (Q) and
screws (P) and place the wire feeder on it.
•
Place the gas cylinder on the cylinder support and fix it with the chain provided: the cylinder must
be equipped with pressure regulator. For the connection between the generator and the separate
wire feeder use the interconnection cables provided.
•
Place the power source in a well ventilated area: dust, grit or any other thing that may obstruct the
air intake and output vents can prevent the ventilation and good operation of the welder.
3.2
TORCH LEAD ASSEMBLY – EURO
CONNECTION (fIG.3)
•
Plug the torch hose into the socket on the front of the
welder and secure by hand screwing in the threaded
connection.
3.3
TORCH LEAD ASSEMBLY – DIRECT CONNECTION (fIG. 4)
•
Before fitting the torch hose assembly (7) on the machine remove the nut (1) and the washer (2). Then,
measure the length of the liner from the brass nut (10). This measurement should be a maximum of
20mm, and should be carefully trimmed to this length using a good pair of side cutters, or similar,
-ENGLISH-
assemBlY
M
I
Q
L
N
O
F
G
H
P
D
C
FIG. 3
FIG. 2
E
F
A
B
23
Publicité
Table des Matières
