Publicité
Les langues disponibles
Les langues disponibles
Installation Instructions – EON Wall Mounted Fixture 303-W1/303-W2
IMPORTANT SAFETY INFORMATION - READ, FOLLOW, AND SAVE ALL SAFETY AND INSTALLATION
Product must be installed in accordance with all National Electrical Code, Canadian Electrical Code, and all Local
●
●
and Provincial Codes.
Follow product label information and instructions before installing fixture. Retain installation instructions for future
●
●
reference.
Wiring and installation to be performed by a qualified electrician only. Turn OFF power before initial installation,
●
●
servicing and maintenance.
To reduce the risk of FIRE OR INJURY TO PERSONS: Lighted lamp is HOT! Turn OFF fixture and allow to cool
●
●
before replacing lamp. Do not touch hot lens, guard, or enclosure. Keep away from combustible materials. Do not
touch the lamp at any time. Use a clean, dry, soft cloth to handle the lamp. Oil from skin may damage the lamp.
Replace lamp only with correct wattage and type of lamp marked on label. DO NOT exceed the maximum wattage
●
●
listed on the fixture label.
Keep fixture lens area clear and free from debris as this may cause an unsafe condition.
●
●
The use of accessory equipment not recommended by the manufacturer may cause an unsafe condition and void
●
●
product warranty.
All gaskets, O-rings and sealing surfaces must be kept clean during installation and service; failure to do this may
●
●
cause an unsafe condition and void product warranty.
Use UL listed waterproof wire connectors when making electrical connections (recommended).
●
●
Replace removable parts after servicing.
●
●
IMPORTANT WARNINGS, LISTINGS AND CERTIFICATIONS SPECIFIC TO FIXTURE
SUITABLE FOR WET LOCATIONS.
●
●
SUITABLE FOR MOUNTING WITHIN 1.2M (4ft) OF THE GROUND.
●
●
SUITABLE FOR OPERATION IN AMBIENT NOT EXCEEDING 40°C.
●
●
FOR INSTALLATION USE SUPPLY CONDUCTORS RATED 60°C.
●
●
ATTENTION: Limit range of adjustment to a minimum of 45° away from mounting plate.
●
●
ATTENTION: No user serviceable parts.
●
●
HARDWARE REQUIRED FOR INSTALLATION (PROVIDED BY OTHERS)
5/64" Allen Wrench
●
●
9/64" Allen Wrench
●
●
Phillips Screw Driver.
●
●
Wire connectors (recommend silicone filled outdoor rated wire connectors)
●
●
2
WARNING
INSTRUCTIONS.
Installation Instructions – EON Wall Mounted Fixtur e 303-W1/303-W2
ADL141237
www.cooperlighting.com
Publicité
