SOLIS GRILLMASTER TOP 794 Mode D'emploi page 114

B . CLOSED USAGE AS CONTACT GRILL OR SANDWICH MAKER
1. Check if the grease drip tray is fully inserted into the appliance base.
2. Check if both hot plates are properly locked into place.
Note: Should the plates be improperly mounted, „INSERT PLATE" will be stated
on the LCD screen. In this case, unfasten both plates with the corresponding plate
release buttons and reinstall them so that they audibly lock into place.
Exact instructions you can find on p. 109 of this manual.
3. Place the grill on an even, dry and heat resistant
worktop. Ensure that to the left and right of the
appliance, at least 10 cm of space are kept to
other items.
4. Completely unwind the power cord and plug
the power plug into a suitable wall outlet.
5. A signal will sound and the LCD screen will
state „OFF" and „0" for the time setting.
6. Setting the temperature to heat the grill:
a) Ensure that the grill is closed with the top hot plate lying on the bottom hot
plate. The slider for closing and opening the grill (L) should be set to „OPEN".
In this position, the appliance can quickly and efficiently heat up.
b) Turn the temperature regulator (H), to set the
desired grilling temperature. Set the regulator to
SEAR (210°C – 230°C) to heat up quickly,
PANINI (180°C – 205°C) to make sandwiches or
LOW (160°C – 175°C) resp. to another tem-
perature in between. You can choose temper-
atures in steps of 5°C (or 10°F). Once the tem-
perature is set, the grill will heat up, the LCD
screen will light up orange and display the cho-
sen temperature and „0" for the time setting.
The control notice HEATING will flash.
c) Let the grill heat up until HEATING is not longer displayed.
Note to the temperature unit:
Your grill is equipped with a temperature unit switch (F), which can be found to
the lower left of the LCD screen. Standard temperature setting is Celsius, it can
be changed to Fahrenheit by pressing the switch (F). The resp. indicator °C or
°F will be displayed.
If you have set the temperature display to Fahrenheit, it will save this setting un-
til you press the switch again or pull the power plug. After reconnecting the plug
to the wall outlet, the standard setting Celsius will be displayed again.
114