Sirius S900 Instructions D'utilisation Et Avis De Montage page 15

Exausting version
Connect the flange to the exhausting hole with
an appropriate pipe. Connect the appliance
with the electrical mains through the supply
cord.
Filtering version
Connect the flange with a pipe suitable to convey
the air to the top of the cabinet. Connect the ap-
pliance with the electrical mains through the sup-
ply cord.
WORKING
Mod. SM900 (fig. 9) SM905
A: Light switch on/off
B: Motor switch on speed 1/off
C: Motor switch on speed 2
D: Motor switch on speed 3
E: Warning gem
Mod. SL900 (fig. 10)
A: Light switch on/off
B: Motor switch on speed 1/off
C: Motor switch on speed 2
D: Motor switch on speed 3
E: Motor switch on speed 4
F: 10-minutes timer
Mod. SLT 900: use the remote control (Fig. 11)
RC001
R C
ADIO
ONTROL
Radio control used for the remote operation of
ducted cooker hoods.
TECHNICAL DATA
- Alkaline battery powered: 12V mod. 27A
- Operating frequency: 433.92 Mhz
- Combinations: 32.768
- Max. consumption: 25 mA
- Operating temperature: -20 ÷ + 55 °C
- Dimensions: 130x45x15 mm.
OPERATING DESCRIPTION
The transmitter is equipped with 5 buttons for coo-
ker hood management, as specified below:
: Light ON/OFF command.
: Motor ON (speed level 1) / OFF command.
: Reduce speed.
: Increase speed.
: 10-minute timer.
INITIAL OPERATING CONDITION
The manufacturer supplies the radio control unit
ready to be used with codes preset in the Factory
OPERATION MODE
Standard configuration:
Standard configuration requires all "cooker hoods
– radio control - system" to be provided with the
same transmission code. In the event two cooker
hoods – radio control system are installed in the
same room or nearby, each system may affect the
operation of the another. Therefore, the code of
one radio control system must be changed.
15