ROBLIN Premium 610 Mode D'emploi Et Installation page 16

• To drill the outlet onto the top of the wall furniture.
• To fix the 2 squares using the provided screws. • To fix the 2 squares using the provided screws.
Caution: The position of the cutting and the
squares could be modified according to the
position of the frame thickness 30 mm.
• To place the anti-backflowflats item 9 over
the round outlet. To secure the connections with
appropriate clamping rings or adhesive tape.
• DUCTING
- In the extraction mode:
To connect the round outlet of the hood via a
rigid or flexible duct of ø 150 mm.
• To secure the connections with appropriate
clamping rings or adhesive tape not provided.
• To remove the possible charcoal filte.
- In the recirculation mode:
The filtered air is evacuated in kitchen through an
outlet placed on the top of furniture or the hood.
• To drill a hole of ø 155 mm on the top of furniture.
• To connect the round outlet of the hood via a rigid
or flexible duct of ø 150 mm to the outlet on the to
of the furniture.
• To secure the connections with appropriate
clamping rings or adhesive tape not provided.
• To fix the charcoal foam onto the metal filters
using 2 X 4 barettes.
• The hood can be connected to the mains supply via a double-pole switch having 3mm minimum
contact gap on each pole.
• To insert the hood into the cutout and to fix it using the screws provided on squares.
EN
12a
12b
15 min. - 30 Max.
X = Epaisseur porte
150
15