ROBLIN Premium 610 Mode D'emploi Et Installation page 15

INSTALLATION
Any permanent electrical installation must comply with the latest regulations concerning this type of instal-
lation and a qualified electrician must carry out the work. Non-compliance could cause serious accidents
or injury and would deem the manufacturers guarantee null and void.
ATTENTION: Do not forget to use adequate plugs to the support brackets. Enquire after the manu-
facturers. Do an embedding if necessary. The manufacturer accepts no responsibility in case of a
faulty hanging due to the drilling and the setting up of plugs.
• The Hood can be fitted onto
the lower surface of the wall furniture.
(650 mm min. from the surface of the cooking
appliance to the underside of the cooker hood.)
• To carry out a cutting (embedding) on
the lower surface of the wall furniture,
as indicated.
Caution: The position of the cutting and the
squares could be modified according to the
position of the frame thickness 30 mm.
• A plate of compensation of 50,40 or
20 mm (provided) can be fixed at the back
hood EVOLIA. If necessary, one
precut on the plates of compensation
of 40 and 20 mm allows to obtain 30 and 10 mm.
To unscrew the 3 screws located between the lamps.
To remove lighting bracket in order to reach
fixings of the plate of compensation.
EN
Drilling the Support surface and Fitting the Hood
3
2
1
14