KREAFUNK aSOUND Manuel D'utilisation page 6

2. Charge aSOUND
1. Connect aSOUND with AC
adapter directly (included).
2. Red LED turns ON during
charging, turns OFF when fully
charged.
3. Unplug AC adaptor when fully
charged.
Note:
The Red LED will flash and make
a sound when the battery power is
low (<21%).
3. Starting aSOUND Blue-
tooth Speaker
1. When fully charged, hold down
the POWER button to turn on
the speaker.
2. aSOUND is on standby mode
after power-on if the blue LED
blinks quickly.
3. aSOUND will turn off for power
saving if it is not in use in 10
minutes.
4. Press any button located on the
top to activate aSOUND from
6
standby mode.
5. To manually turn off aSOUND
Speaker, hold down the POWER
button.
4. Pairing with Bluetooth
enabled devices
(Mobile phones/Tablets etc.)
1. Keep the speaker and device
within 1 meter of each other.
2. Hold down the power button
for 2 seconds to turn on the
speaker, the LED indicator will
blink quickly in blue while the
speaker enters search mode.
3. Start the Bluetooth function on
your mobile device and look
for "aSOUND" in the Bluetooth
device list (depending on the
Bluetooth version of your
device you may have to enter
the pass code '0000').
4. After successfully connecting,
the LED will change to solid
blue.
Note:
English