Agrilaser Autonomic Mode D'emploi page 13

Orange continuously: The Agrilaser is in teaching mode (the user creates a
new pattern or edits an existing pattern).
Orange blinking: The Agrilaser is in standby mode. No patterns will be
executed. Connect the Agrilaser Autonomic to your computer, execute the
software and press 'Start' in the overview screen to activate the Agrilaser
Autonomic.
Green continuously: The Agrilaser Autonomic is preparing the system for
bursting (laser is still off) or is performing a burst (laser is on).
Green blinking: At this point the Agrilaser Autonomic is waiting to perform
its next burst. This can either be during the interval in between bursts or
because the current time is outside the activated timeslot(s). The laser will
start bursting again only if at least one pattern has been created and has
been assigned an active timeslot.
None: The Agrilaser is either switched off, not connected to a power source
or the emergency switch has been activated. Make sure all cables are
connected properly and the power adapter is connected to a power source.
In addition, check if the emergency button is released. Press the ON/OFF-
button to turn on the system.
The Agrilaser Autonomic wil shut down in case of a power cut. After
loss of power the Agrilaser Autonomic must be switched on again
manually, by pushing the ON/OFF button.
If problems keep occurring after troubleshooting attempts, please contact
your local Agrilaser dealer.
User manual Agrilaser Autonomic
®
EN
FR
DE
NL
ES
PT
IT
RU
13 13