Astralpool EVOLine 6 Manuel D'instructions page 11

EN
1.2 Pool system set up
Heat Pump
Water processor Side connection valve
Outlet
Power cable inlet Inlet
Condensed water draining pipe
Water pump
Filter
Pool water inlet
Draining nozzle Discharge water to pool
1.3 Warning :
- Do not place your hand or any other objects into the air outlet and fan. It could damage the heat
pump and cause injuries;
- In case of any abnormality with the heat pump, cut off the power immediately and contact a
professional technician;
It is strongly advised to place a protective guard around the unit to keep children away from the heat-
pump. An authorized electrician must connect the Heat Pump to the power. (230V 1ph or 400V 3ph)
Important—Although the heat pump is electrically isolated from the rest of the unit, this only
prevents the passage of electricity to or from the pool water. Grounding the unit is still required to
protect yourself from short circuits inside the unit. Make for adequate ground connection.
Check if the electrical mains voltage corresponds with the operating voltage of the heat pump prior to
hooking up the unit.
230V / 1ph / 50Hz 380 - 400V / 3ph / 50Hz
11