Installation; Start-Up; Initial Start-Up - Häfele WT 210 Mode D'emploi

5. Installation

6. Start-up

6.1 Initial start-up

22
WARNING
Risk of fatality due to failures or faults in electromagnetically sensitive
devices!
The electromagnetic radiation of the product can cause faults in sensitive parts
(e.g. in medical equipment).
The functionality thereof will be adversely affected.
> Do not place product close to electromagnetically sensitive devices.
> Pay attention to the safety instructions for the electromagnetically
sensitive devices.
> If you have any doubts regarding compatibility, please contact the
manufacturer.
NOTE
Damage to product due to damaged wires!
Damaged wires affect the functionality of the product.
> Do not trap or damage wires during installation.
> Never start up and use the product if any wires have been damaged.
The installation instructions are a separate document and are enclosed with the
product. They are exclusively intended for:
• The operator
• The installation and start-up personnel
The product is supplied in so-called simple operation mode for stand-alone
operation (SA). These instructions only describe how to start up in this operation
mode.
• Details of use of the product with software applications can be found in the
relevant software documentation.
• The "Stand-Alone" operation mode will be permanently shut off once the product
is configured for the first time using the Dialock MDU. After that, reactivating this
operation mode is only possible after a reset. A reset is only possible in
combination with an MDU programming unit.
The work operations only need to be carried out once during initial start-up.
NOTE
Malfunction due to outdated Dialock firmware
To ensure that the current Dialock firmware is running on the terminal, the
device has to be flashed (programmed) using the mobile programming unit
(MDU) during start-up. In case of questions concerning the firmware version
or the procedure please contact Häfele.