Fitting Of Two Channel Control Units In The Rack - THOMSON TTV 1707 Manuel D'utilisation

128
8. Place the accessory in the accessory rack (accessory attachment is to be adapted
according to its type and brand).
9. Place the CCU DT500 + accessory assembly in the 19" rack at the location required
and attach it using both lugs.

2.1.2 - Fitting of two Channel Control Units in the rack

EQUIPMENT AND TOOLS REQUIRED:
• Reference kit BDT05700AA.
• One screwdriver.
1. Remove the right-hand lug from the CCU DT500 located to the left by unscrewing
both the attaching screws.
2. Remove the left-hand lug from the CCU DT500 located on the right by unscrewing
both the attaching screws.
3. Remove the CCU DT500 power supply located to the left by unscrewing the 3
attaching screws.
4. Place the front cover against the left-hand side of the CCU DT500 located to the right
(only one position correct).
THOMSON TTV1707 / CCU DT500
User manual
Chapter 2 - Installation
Installation of ccu in rack
B1707M00LD
September 2000