Activation Of The Line Current Detection Function - KLS Martin group marVac smart Vac Mode D'emploi

5.2

Activation of the line current detection function

The line current detector is a separate marVac
additional activation sources (local footswitch or remote activation via MCB). If activation of the fan via the
line current detector is wanted, this function must be activated in the setup menu. If activation of the fan
via the line current detector is not wanted, this function can also be deactivated without requiring changes
to the installation and configuration of the line current detector.
• To activate or deactivate the line current detection function, open the setup menu and select the
Setup menu. See section 5.1, "Setup menu," page 42.
• Then activate or deactivate the function using the up and down button:
Activate line current detection function
Initial state
Setup menu for line current detection with
deactivated line current detection function
Deactivate line current detection function
Initial state
Setup menu for line current detection with activated
line current detection function
46
marVac® / maXium® smart Vac iDetect external line current detector
®
activation source and can be used independently of
Button Objective
Setup menu for line current detection with activated
Up
line current detection function
Button Objective
Setup menu for line current detection with
Down
deactivated line current detection function
Instructions for Use
Revision 04