KLS Martin group marVac smart Vac Mode D'emploi page 41

marVac® / maXium® smart Vac iDetect external line current detector
Instructions for Use
Status display
immediately after switching on the marVac
red green
after the activation process:
green
every 2 seconds
at any time:
steady red
or:
steady green
at any time:
red green red
Revision 04
The line current is detected via an independent socket for a
mains cable.
• Connect the country-specific power cord (5) included
The line current detector is protected by a T 10 AH, 250 V
fuse.
The assembly of the line current detector is complete.
• Connect the mains cable to the marVac
The line current detector switches on together with the
marVac
The operational status is signaled by the status LED (4).
®
:
red yellow
red
green red green
with the electrosurgery or laser surgery device to the
line current detector.
with the power switch located on the front of the
device.
®
and is ready for operation after about 3 seconds.
Meaning
start code/activation process
ready for operation
hardware or firmware error
bootloader is active
®
and switch it on
41