Features - Danby Designer DUFM283WDD Guide D'utilisation Et Soins De Propriètaire

DOOR REVERSAL
INSTRUCTIONS
CAUTION
To avoid personal injury to yourself and/or property, we
recommend someone assist you during the door reversal
process.
1) To access the lower hinge assembly, tilt back the freezer
cabinet or lay the freezer on its back. (Fig.A)
2) Remove both leveling legs located at the front of the
cabinet.
3) Remove the screws holding the lower hinge assembly to
the cabinet.
4) Remove the main door assembly from the freezer cabinet
(lift door slightly and pull downward).
5) Using a flat head screwdriver, remove the main door top
hinge pin. (Fig.B)
6) Re-install the main door top hinge pin on the opposite
side of the cabinet.
Fig. A
1) THERMOSTAT DIAL: For controlling the
temperature inside the freezer. Turns the motor
on as soon as the temperature rises above the
desired level.
2) REFRIGERATED SHELVES:3 full width
refrigerated shelves.
3) MAGNETIC GASKET: Tight fitting door seal
keeps all the cooling power locked inside. No
hooks or latches.
4) DOOR BINS (4)
5) DRIP TRAY
INSTALLATION INSTRUCTIONS

FEATURES

If you find the direction of opening the door on your
appliance inconvenient, you can change it by following
the steps shown in the below diagrams.
7a) Remove the door plug and door bushing located on the
top of the main door.
7b) Interchange their positions (eg.door plug right side, door
bushing left side).
8) Re-install main door assembly on cabinet.
9) Remove door bushing (bottom door) and install on
opposite side.
10) Re-install the lower hinge assembly on the opposite side.
11) Make sure the door assembly is properly aligned on the
cabinet before tightening lower hinge screws.
12) Re-install both leveling legs. The process is now
complete.
Fig. B
1
2
5
2
3
4