Replacing The Flaps - Tennant S8 Mode D'emploi Et Pièces Détachées

5.8 -REPLACING THE FLAPS

5.8.1 -Outer side flaps
To replace the side flaps pos.1 Fig.11 , remove the rear wheels and the
relevant side guards. Loosen the screws that secure the flaps to frame pos.2
Fig.11 and replace the old flaps with new ones.
5.8.2 -Inner side flaps
To replace the inner side flaps pos.5 Fig.11 , lift the front part of the machine
and loosen screws pos.6 Fig.11 that secure the flaps to the frame. Replace
the old flaps with new ones.
5.8.3 -Center flaps
- Remove the rear wheels and the relevant side guards.
- Remove the rear door.
- Loosen the two flap fixing pins pos.3Fig.11 , located on the sides of the
frame.
- Grasp flap pos.4 Fig.11 and pull it outwards.
Remounting:
- Fit the flaps in the same direction in which they are removed.
- Insert the two references in their holes.
- Tighten the two fixing pins and reassemble the machine.
3
1
1
5
4
6
6
5
1
5.9 -REPLACING THE TRACTION CABLE
5.9.1 -Remove the traction cable as follows
To replace the traction cable proceed as follows:
- Remove the upper bonnet of the machine.
- Loosen the security dowel located on the cable fixing pin.
- Pull the cable out of the fixing pin and remove the adjusting
screw mounted on the handle.
To remount the cable:
- Fit one end of the cable into the adjustment screw of the
handle (i.e. the end without the blocking ball).
- Insert the cable into its sheath.
- Hook the blocking ball to the handle.
- Slot the cable through the turned adjustment screw secured to
the machine frame and then through the fixing pin.
- Tighten the security dowel.
The position of the cable is adjusted by acting on the two
adjustment screws.
5.9.2 -Replacing the side brush lifting cable
To replace the side brush lifting cable, proceed as follows:
- Remove the upper cover and the front bin of the machine.
- Remove the front bumper, the right wheel and the right hand
side guard.
- Loosen the cable clamp.
- Loosen the security dowel on the fixing pin.
- Remove the handle from the support and open it up.
- Pull the cable out of the two sheaths.
To remount the cable:
- Put the cable inside the handle.
- Close up the handle and fix it to its support.
- Insert the cables into their sheaths.
-Secure one end of the cables in place with the clamp and the
other end with the fixing pin.
The position of the cable is adjusted by acting on the two
adjustment screws.
3
2
Fig. 11
13