Bosch GRL 400 H Professional Notice Originale page 20

20 | English
Battery Charger
Permitted battery temperature during charging
Charging time
Number of battery cells
Rated voltage (per battery cell)
Weight according to EPTA-Procedure 01:2014
Protection class
Laser receiver
Article number
Receivable wavelength
A)
Working range (radius)
Reception angle
Receivable rotation speed
B)C)
Reception accuracy
– "Fine"
– "Medium"
Operating temperature
Storage temperature
Max. altitude
Relative air humidity max.
Pollution degree according to IEC 61010-1
Battery
Approx. operating time
Weight according to EPTA-Procedure 01:2014
Dimensions (length × width × height)
Protection rating
A) The working range may be reduced by unfavourable environmental conditions (e.g. direct sunlight).
B) Dependent on the distance between the laser receiver and the rotary laser and on the laser class and laser type of the rotary laser
C) The reception accuracy may be reduced by unfavourable environmental conditions (e.g. direct sunlight).
D) Only non-conductive deposits occur, whereby occasional temporary conductivity caused by condensation is expected.
For clear identification of your laser receiver, see the serial number (28) on the type plate.
Laser receiver noise information
The A-weighted sound pressure level of the audio sig-
nal is up to 95 dB(A) at 0.2 m away.
Do not hold the laser receiver close to your ear!
Assembly
Measuring Tool Power Supply
The measuring tool can be operated either with commer-
cially available non-rechargeable/rechargeable batteries or
with a Bosch battery pack.
Operation with batteries/rechargeable batteries
It is recommended that you use alkaline manganese or re-
chargeable batteries to operate the measuring tool.
1 609 92A 5S3 | (09.09.2020)
°C
h
V=
kg
IP 65 (dust-proof and protected against water
To remove the battery compartment (7), turn the locking
mechanism (8) to position . Pull the battery compartment
out of the measuring tool and insert the non-rechargeable/
rechargeable batteries.
When inserting the batteries, ensure that the polarity is cor-
rect according to the illustration on the inside of the battery
compartment.
Always replace all the batteries at the same time. Only use
batteries from the same manufacturer and which have the
same capacity.
Slide the battery compartment (7) into the measuring tool
and turn the locking mechanism (8) to position .
Take the batteries out of the measuring tool when you
u
are not using it for a prolonged period of time. The bat-
teries can corrode and self-discharge during prolonged
storage in the measuring tool.
CHNM1
0 to +40
14
2
1.2
0.12
/II
LR 1
3 601 K15 40.
635−650 nm
0.5–200 m
120°
−1
> 200 min
±1 mm
±3 mm
–10 °C to +50 °C
–20 °C to +70 °C
2000 m
90 %
D)
2
1 × 9 V 6LR61
50 h
0.25 kg
148 × 73 × 30 mm
jets)
Bosch Power Tools