Sicam JUMBO TCS60 Notice Originale page 38

en 38 | JUMBO TCS60 | Operating instructions
i
Use mounting paste for complete detachment of tire
and rim.
i
For demounting of particularly hard supersingle
textile-reinforced tires or tubeless tires with high
edge balcony design rims refer to the instructions for
demounting of agricultural wheels.
i
To make demounting operations easier it is possible
to use the tubeless tire roller (1).
Demounting of agricultural wheels
1. While operating the tool movement control, rotate
the tool so that the disk faces the side of the tire
that has to be bead-broken and, by means of the
working arm movement control, lock the operating
arm.
|
301 971 2010-11-18
2. By activating the working arm shifting control, posi-
tion the bead breaking disk in correspondence with
the inner edge of the rim.
3. By activating the working arm shifting control, use
the bead breaking disk to press the tyre heel to-
wards the rim centre and, use the pedal to turn the
tightening flange without interruption until the tyre
leaves the rim completely.
i
Use mounting paste for complete detachment of tire
and rim.
4. When the operation has been completed, by acti-
1
vating the working arm shifting control, move the
working arm away from the rim and by activating the
working arm movement control, release the working
arm.
5. Using the trolley movement control, shift the trolley
in the inner side of the tire, and, by means of the
tool movement control, rotate the tool so that the
disk faces the side of the tire that has to be bead
broken.
6. Operating the working arm movement control, lock
the working arm.
7. Repeat in the same way bead breaking (point 3) on
the other side of the tire.
8. Operating the working arm movement control, tilt
the working arm and press the pedal to bring it on
the front part of the tire. Lock again the working arm
to the trolley by adjusting the special pin and making
the mounting tool tilt.
9. By activating the working arm shifting control, posi-
tion the bead breaking disk in correspondence with
the inner edge of the rim.
Sicam srl società unipersonale