Installation; Checks; Fitting The Cmm Easy; Connecting The Cmm Easy - Simco CMM Easy Notice D'utilisation

5 Installation

Warning:
- The electrical installation must be carried out by an electrical engineer with the
relevant training and qualifications.
- Disconnect the power supply before carrying out work on the unit.
- The CMM Easy must be properly earthed. Earthing is needed to ensure proper
operation of the equipment and to avoid electrical shocks upon contact.

5.1 Checks

- Check that the equipment is undamaged and that you have received the correct version.
- Check that the data on the packing slip corresponds to the data shown on the product
received.
- Check that you have received a connection cable with a 5-pin M12 connector (female).
A standard connection cable can be obtained from Simco-Ion Netherlands or from the agent
in your region.
See the spare parts list on page 37.
If the connection cable is to be fitted through a cable carrier, please use the special flexible
connection cable available from Simco-Ion or another type that is suitable for this purpose.
If you have any problems or are unsure, please contact Simco-Ion Netherlands or the agent in
your region.

5.2 Fitting the CMM Easy

The CMM Easy must be fitted so that the connection cables of the charging electrode are within
reach of the electrode head; preferably so that the electrode head can be removed without
dismantling the entire generator.
- Fasten the generator to a stable machine part or to the end of an IML robot arm using the
four ø6 mm assembly holes in the assembly plate.

5.3 Connecting the CMM Easy

- Connect the earth wire to a guaranteed earthing point on the machine.
- Connect the M12 connector of the connection cable to the generator.
- Safely route the connection cable to the 24 V power supply and the control unit.
- Connect the cable as shown in figure 4.
- Route the high-voltage cable to the electrodes and shorten it where possible.
- Make sure that directly connected charging electrodes (without series resistors) do not touch
or come too close to earthed objects.
- Connect the high-voltage cable(s) to the electrode(s), bearing in mind that voltages of up to
18 kV can be generated.
- Turn the locking screw right into the housing of the CMM Easy.
- Slide the electrode head onto the generator.
- Manually turn the locking screw upwards until it is securely fastened in the
electrode head.
CMMEasy_UM_9752098500_NL_D_GB_F_V2_0
GB
31