Hendi 240502 Mode D'emploi page 9

Faults:
Fault
Appliance does
not do anything
Appliance does
not reach the
set temperature
Overload circuit breaker tripped
This appliance is fitted with an automatic overload circuit breaker.
To make the appliance operational again, first allow the appliance to cool down, then fill with
additional water.
Spare parts:
Article number
928639
Warranty
Any defect affecting the functionality of the appliance that becomes apparent within one year after
purchase will be corrected by free repair or replacement provided the appliance has been used and
maintained in accordance with the instructions and has not been abused or misused in any way.
Your statutory rights are not affected. If the appliance is claimed under warranty, state where and
when it was bought and include proof of purchase (f.e. receipt).
In line with our policy of continuous product development we reserve the right to change the
product, packaging and documentation specifications without notice.
Discarding & Environment
At the end of the life of the appliance, please dispose of the appliance according to the regulations
and guidelines applicable at the time.
Throw packing materials like plastic and boxes in the appropriate containers.
For technical information and Declarations of Conformity see www.hendi.eu
Symptom
Red lamp does
not light and
green lamp does
not light.
Green lamp does
not light, red lamp
does.
In case of any doubt, always contact your supplier!
Cause
No mains
voltage
Thermostat
defective
Element
defective
Description
Bain marie container GN ½ 150mm
Possible solution
Check the power supply.
Contact your supplier.
Contact your supplier