Num'axes PIE 1010 Guide D'utilisation page 31

Serial number
Factory setting
Download the
PC-Software
Version
SMTP / MMS setup:
IMPORTANT
Only still photos can be transmitted wirelessly, not videos.
The camera will not send videos to your phone or email. In Video or Camera + Video
mode, it will only alert you by SMS that a video has been captured. The video files are
stored on the SD card for later review.
MMS settings
Piège photographique / Trail camera # PIE 1010 – Guide d'utilisation / User's guide – indice A
OFF, ON
Allow the user to set a serial number for the camera (4 digits). Useful
for ID purposes when multiple cameras are setup, since each camera
will imprint its name on all photos.
Enter (followed by an additional Cancel/OK step)
Press OK to enter then select "OK" to restore all parameters to the
original factory default settings.
Download the camera setting up software from the camera.
This parameter shows the information about firmware of the camera.
if you want to receive the photos on your mobile
phone by MMS
MMS status
There are 4 MMS status.
OFF (default setting) : the camera will shut off the MMS function
800x600 : the camera will send 800x600 pictures
VGA : the camera will send VGA pictures (640x480)
SMS : the camera will send SMS
The camera will capture and store on its SD card high resolution, full
quality images regardless of the setting you choose.
MMS number/day
0 – 100
You can choose the maximum number of pictures you want the
camera to send within a 24-hour period.
If the device is on Camera mode and you set the MMS number at 30,
it will send up to 30 MMS within 24 hours. And then it continues to
capture photos and save them on the SD card. After 24 hours, the
camera will send MMS again when it captures photos.
0 = unlimited number of MMS
Note: if the device is in Video mode, it will send only SMS instead of
MMS.
31/40