Sharp SJ-MB300S Mode D'emploi page 8

CARE AND CLEANING
WARNING
Unplug the refrigerator first to prevent electric
■
shock.
Do not splash water directly on the outer cabinet or
■
the interior. This may lead to rusting and
deterioration of the electrical insulation.
IMPORTANT
To prevent cracking on inside surfaces and plastic
components, follow these tips.
• Wipe any food oils adhered to plastic components.
• Some household chemicals may cause damage, so use
only diluted washing-up liquid (soapy water).
• If undiluted detergent is used or soapy water is not wiped
off thoroughly, cracking of plastic parts can result.
1
Remove the accessories e.g. shelves from the cabinet
and door. Wash them in warm soapy dishwashing
water; rinse in clean water and dry.
2
Clean the inside with a cloth soaked in warm soapy
dishwashing water. Then, use cold water to wipe off
soapy water.
3
Wipe the exterior with a soft cloth each time it is soiled.
4
Clean the Magnetic door seal with a toothbrush and
warm soapy dishwashing water.
5
Wipe the control panel with the dry cloth.
<How to remove the wine bar case>
1
Push the cover.
2
Pull out the case with holding it
up slightly.
(The cover is not removed)
<How to remove the refrigerator shelf>
Pull it out with holding it up slightly.
<How to attach the refrigerator shelf>
Push it along the rail and push it with holding it up
slightly at the end. (If it is pushed without holding it up,
the rail of internal wall may be damaged.)
8
NOTE
• To prevent damage to your refrigerator, do not use heavy
duty cleansers or solvents (lacquer, paint, polishing powder,
benzine, boiled water, etc.).
•
If the power supply is disconnected, please wait for at least
5 minutes before re-connecting power.
• When dropped the juice and the like near the control panel,
wipe off directly. It becomes cause of failure of the control
panel.
•
Do not drop objects inside the refrigerator or strike the inner
wall. This may cause the inner surface to crack.
Defrosting
Defrosting is fully automatic due to a unique energy saving
system.
When the refrigerator LED light is
blown
Contact the service agent approved by SHARP to request
a replacement compartment light. The compartment light is
not to be removed other than by qualified service
personnel.
When the power supply is shut down
due to an electric power failure or
other causes
The setting when the electricity is turned ON again is
shown below.
Plasmacluster
Temperature setting
(refrigerator / freezer compartment)
The temperature zone of the wine bar
(Only for SJ-MB300S)
Operation sound
Child lock
Switching off your refrigerator
If you switch your refrigerator off when you are going away
for an extended period, remove all food, clean the interior
thoroughly. Remove the power cord plug from the power
socket and leave all doors open.
The setting
before the
electric power
failure is held.