Elipson PF 6B Manuel D'utilisation page 24

of the voices (close speakers).
•Secondly, move the speakers away from the rear wall by steps of 10 cm to find the
balance between the depth of the sound image (far from the back wall) and the level of
the extreme low frequencies (close to the back wall).
•Finally, adjust the loudspeakers orientation by turning them gradually toward the center
of the listening area. If you leave the speakers parallel, you may want to bring them closer
together, if you orient them more than 30°, you may increase their spacing.
2. Connections
ALL THE CONNECTIONS MUST BE MADE WITH THE EQUIPMENT TURNED OFF.
It is essential to connect the speakers using the correct polarity. Make sure to connect the
" + " terminal of the speaker (Red) to the " + " output terminal of the amplifier. Then, make
sure to connect the " - " terminal of the speaker (Black) to the " - " output terminal of the
amplifier. A wrong connection would cause a cribled stereo image and loss of bass. Use
high quality speaker cable. Elipson speakers are supplied configured for use in a single
wired mode or bi-wiring. Bi-amp is also possible (see page 31).
•FL
~60°
•FR
> 30cm
> 30cm