What To Do If - Kuppersbusch ITE128-7 Notice D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

What to do if...

Warning! Before troubleshooting,
disconnect the mains plug from the
mains socket.
Only a qualified electrician or competent
person must do the troubleshooting that
is not in this manual.
Problem
The appliance does not
operate. The Pilot light
does not flash.
The Pilot light flashes.
The Alarm light flashes.
The compressor operates
continually.
The temperature in the
freezer is too low.
The temperature in the
freezer is too high.
There is too much frost.
Possible cause
The appliance is switched off.
The mains plug is not connected
to the mains socket correctly.
The appliance has no power.
There is no voltage in the mains
socket.
The appliance is not working
properly.
The temperature in the freezer is
too high.
The temperature is not set cor-
rectly.
The door is not closed correctly.
The door has been opened too
frequently.
The product temperature is too
high.
The room temperature is too
high.
The Fast freezing function is
switched on.
The temperature regulator is not
set correctly.
The Fast freezing function is
switched on.
The temperature regulator is not
set correctly.
The door is not closed correctly.
The product temperature is too
high.
Many products are stored at the
same time.
Products are too near to each
other.
Food is not wrapped correctly.
The door is not closed correctly.
Important! There are some sounds during
normal use (compressor, refrigerant
circulation).
Switch on the appliance.
Connect the mains plug to the
mains socket correctly.
Connect a different electrical appli-
ance to the mains socket.
Contact a qualified electrician.
Contact a qualified electrician.
Refer to "Excessive Temperature
Alarm"
Set a higher temperature.
Refer to "Closing the door".
Do not keep the door open longer
than necessary.
Let the product temperature de-
crease to room temperature before
storage.
Decrease the room temperature.
Refer to "Fast freezing function".
Set a higher temperature.
Refer to "Fast freezing function".
Set a lower temperature.
Refer to "Closing the door".
Let the product temperature de-
crease to room temperature before
storage.
Store less products at the same
time.
Store products so that there is cold
air circulation.
Wrap the food correctly.
Refer to "Closing the door".
37
Solution

Publicité

Table des Matières
loading

Table des Matières