Installing Your Unit - Impecca IPAC16-BRB Manuel De L'utilisateur

INSTALLING YOUR UNIT

INSTALL WINDOW FILLER PANELS
The set of window filler panels is designed for installation in most vertical or horizontal
sash windows. You may be required to slightly modify your specific installation to ensure
safe and proper use of your air conditioner unit.
NOTE: The window panel cannot be installed in windows less than 22"(559mm) wide as
you will be unable to shut the exhaust cover.
STEP 1: Attach the protective grille to the
window panel. Push the grille firmly to ensure
that its four projections fit into the holes in the
window panel.
STEP 2: Cut the foam seal to the
proper length and attach it to the
window sill.
STEP 3: Attach the window panel to the windowsill.
A) If the inner width of the window is between
22"(559mm) and 24"(609mm) wide:
1. Remove the adjustment panel from
the window panel and cut the window
panel to the same width as the win-
dow frame opening.
2. Open the window and
place the window panel on
the windowsill.
3. Secure the window panel
to the windowsill with 2
screws.
Protective grille
Foam seal A
(adhesive type)
Window
panel
Screws
22" - 24"
–11– –11–
Exhaust cover
Cut
Adjustment panel
Window panel
Windowsill