Terminal Boards - CAME PLACO-C Manuel D'installation

1
2
110

Terminal boards

B
M1
Selections
INT
1
2
Installation
Remove the unit from the plastic support by sliding it after pressing the plastic button (figure 1).
Fasten the plastic support to the round built-in box of Ø 60 mm (figure 2) or to the rectangular box 503 (figure
3) or to the wall (figure 4), using the provided screws and observing the UP indication .
The box must be fitted at a suitable height in relation to the installer.
Avoid excessive tightening of the screws.
Once the connections have been made, attach the terminal to the plastic support (figure 5-6).
To release the unit from the plastic support, press the plastic hook and lift the terminal (figure 7).
1
2
5
31
60
–
1/2
3/4
INT
1
INT
1/2 3/4
2
INT
1/2 3/4
BIANCA-C
3
6
Technical features
Absorption: 80 mA max (<1 mA stand-by)
Single LED absorption (ring disabled): 1 mA
Dimensions: 110x170x31 mm
Storage temperature: -25 °C +70 °C
Operating temperature: 0 °C +35 °C
IP degree: IP 20
B
–
The INT jumper is used to create two sepa-
rate intercom groups: leave the INT jumper
in position "1/2" on the receivers of the first
group and move the INT jumper to position
INT
"3/4" on the receivers of the second group.
1/2 3/4
INT
1/2 3/4
1
2
BUS line input (not polarised)
Doorbell
4
7
EN
3