Treatment Steps; Cleaning And Maintenance; Cleaning The Main Unit And Treatment Tips - Silk-n H4201 Mode D'emploi

8.2 Treatment steps

EN
1. Make sure your skin is clean, dry and free from powder, cream
or gel.
2. Make sure the rubber cap
are firmly in place on the main unit
We recommend that you start with the fine treatment tip (see
section "Attaching and replacing the treatment tips").
3. Connect the cable of the AC/DC adapter
socket
4. Connect the AC/DC adapter to a mains socket.
5. Press the control button ( )
product is ready for use in the low suction mode.
6. Apply the treatment tip firmly to your skin so that you feel
the suction. Treat each area as recommended in the section
"Treatment areas".
7. If necessary, press the control button ( ) again to change from
low to high suction mode.
8. When done, press the control button ( ) once or twice to
turn the product off (depending on the current suction mode).
9. Disconnect the AC/DC adapter from the adapter socket and
mains socket.
Avoid direct sunlight and apply SPF 30 or higher
immediately after a treatment. You may also wish to
apply a facial mask, or a day or night cream.

9 Cleaning and maintenance

9.1 Cleaning the main unit and treatment tips

1. Disconnect the product from the mains socket.
2. Wipe the main unit
completely dry with a dry cloth.
3. To clean the treatment tips
main unit. Wash the treatment tips with soap and water, then
dry them thoroughly.
It is recommended to replace the treatment tips every
6 months, or earlier if the abrasive ends of the tips are damaged.
15
.
6
with a damp cloth. Then wipe it
4
, filter and treatment tip
2 3
.
4
7
to turn the product on. The
5
, first remove them from the
1
1
to the adapter