Aqua Medic EcoDrift 4.2 Mode D'emploi page 8

To prevent the pump from pulling air, be sure to place it at least 10 cm | 4 in beneath the surface. To prevent
the pump from disturbing the sand bed, avoid mounting it too close, or pointing it to the bottom of the aquarium.
The pump can be adjusted in any direction by simply turning the magnet (Fig. 1, No. 9), be sure to hold the
pump preventing it from falling, as well as turning the pump in its holder (Fig. 1, No. 6).
Note: Even though the pump comes with a strong magnet holder that holds the pump securely in place, we
recommend to place the pump away from expensive animals in case it becomes dislodged from the aquarium
glass.
The pump is open at the front. Avoid operating the pump via a timer. Small animals could enter the
pump while it is shut-off, and could cause damage to the pump and animals when starting.
Safety instructions
The pump is constructed for indoor aquarium use only. The connection cable and the power plug
Must not be replaced. If the power cable is damaged, the pump must be scrapped.
5. EcoDrift Control 0 – 10 V
To produce irregular flows, the EcoDrift Control is switched between power supply and pump. Protect it from
condensate and respect a
Fig. 2: EcoDrift x.2 Control 0 - 10 V
1. Power input
2. Light sensor connection (at the side)
3. Pump connection
4. Control dial
5. Connection for 0 – 10 volt
Programs:
20 - 100: Speed Mode: Flow of 20, 40, 60, 80 or 100% power. Only in conjunction with W1 and C.
C: Constant flow.
W1:
Frequency and speed can be adjusted. By using the SPEED button, the power can be varied in
steps of 20% between 20 and 100%. By turning the control dial Fig. 2, No. 4) the frequency can
be changed.
W2: The flow is increased slowly and then decreased just as slowly again.
10 min.: If the MODE / FEED button is pressed for 5 seconds, the LED 10 min. lights up. The pump is
stopped for 10 minutes and then starts again. If you want to start it earlier, press the MODE /
FEED button again for 5 seconds.
Random: The flow changes according to the random principle.
8
maximum of 80% air humidity.