TREND T33A Traduction Des Instructions Originales page 9

1 x Synthetic Collection Bag
1 x Hose 5m x 39mm Ø with Hose Spout
2 x Extension Tubes
1 x Curved Metal Tube
1 x High Efficiency Floor Brush
1 x Hard Floor Brush
1 x Power Tool Adaptor
1 x Crevice Tool /Brush
1 x Manual
1 x Guarantee Card
DESCRIPTION OF PARTS
A. Switch ON-OFF
B. Power tool socket
C. Extraction velocity monitor
D. Shaker button
E. Carrying handle
F. Cartridge filter HEPA
G. Collection bag
H. Container
I. Container hose inlet
J. Container deflector flange
K. Lid
L. Container catch
M. Castors
N. Main wheels
O. Hose bayonet fitting
P. Hose 5m x 39mmØ
Q. Extension tubes
R. Curved metal tube
S. Crevice/brush tool
T. Power tool adaptor
U. Hard Floor Brush
V. Hose spout
W. High efficiency floor brush
X. Onboard storage locations
Y. No Foam Filter
Z. Crevis Brush
• Check for damage to the tool, parts or accessories,
which may have occurred during transport. Parts and
accessories may be inside container.
• Take the time to thoroughly read and understand this
manual prior to operation.
EN - T33A
Never modify the appliance or any part of it.
Damage or personal injury could result.
ASSEMBLY
Accessories are secured inside the container. Undo the
three container catches, remove the motor lid, remove
accessories. Turn the container upside down, insert front
castor wheels. Locate main wheels, and click to lock
into place. Turn container right way up. Fit collection
bag (see Inserting and Removing the Collection Bag
-
section). Ensure the cartridge filter butterfly screw is
(Fig. 1)
tight. Refit motor and ensure all three container catches
are fastened.
Inserting Collection Bag
• Unlock the container catches and remove the lid.
• The collection bag has a card-reinforced opening with
a tab at the top.
• Ensure that the collection bag is handled with care to
prevent damage and that is does not get caught or
ripped by the container deflector flange or other sharp
objects or projections.
• Insert the collection bag into the container with the
opening towards the front of the vacuum cleaner.
• Pull the collection bag opening over the container
deflector flange ensuring the collection bag opening
passes over the ridge on the container deflector.
• Ensure collection bag is pushed tight.
• Fold out the rest of the disposal collection bag
downwards into the container.
Take care of the bag to ensure it does not get damaged
when fitting or when removing.
Removing the Collection Bag
-
(Fig. 4)
To remove bag undo the container hose pull bag off the
container deflector flange. Close the bag by flipping the
tab over.
Dispose of the filter in a suitable container according to
the applicable laws.
It is good practice however, to change the bag regularly
to guarantee optimal cooling of the motor.
If the vacuum cleaner is used without the paper dust
bag, it is recommended that the dust container be
emptied and cleaned after each use. this procedure is
also recommended following the suction of any type
liquid.
-9-
WARNING:
-
(Fig. 2)
CAUTION:
-
(Fig 3)