TREND T33A Traduction Des Instructions Originales page 6

DO NOT
use vacuum cleaner in explosive
atmospheres.
This product is not intended for use by persons
(including children) suffering from diminished physical,
sensory or mental abilities; lack of experience. Children
should never be left alone with this product.
ELECTRICAL SAFETY
Power Supply
WARNING:
Before any maintenance work, isolate mains
plug from power source.
The electric motor has been designed for one voltage
only. Always check that the power supply corresponds
to the voltage on the rating plate. Machines marked
for 220-240 volt can also be operated from a 220-volt
supply. The vacuum cleaner is supplied from the factory
with mains supply power cord/cable, which has an
earthed plug. It must only be connected to an approved
earthed socket.
Mains Plug Replacement (UK &
Ireland only)
Always check the condition of the cable and plug before
starting with your work. Should your mains plug need
replacing and you are competent to do this, proceed
as instructed below. If you are in doubt, contact an
authorized Trend Repair Agent or a qualified electrician.
• Disconnect the plug from the supply.
• Cut off the plug and dispose of it safely; a plug with
bared copper conductors is dangerous if engaged in a
live socket outlet.
• Only fit 13 Amperes BS 1363A approved plugs fitted
with a 13 Amp A.S.T.A approved BS 1362 fuse (1).
• The cable wire colours, or a letter, will be marked at the
connection points of most good quality plugs. Attach
the wires to their respective points in the plug (see top
right).
• Brown is for Live (L) (2), Blue is for Neutral (N) (3) and
Green/Yellow is for earth (4).
• Before replacing the top cover of the mains plug
ensure that the cable restraint (5) is holding the outer
sheath of the cable firmly and that the two leads are
correctly fixed at the terminal screws.
EN - T33A
4
3
5
For 115V units with a power rating exceeding 1500W we
recommend to use a plug to BS4343 standard.
WARNING:
Never use a light socket. Never connect the live
(L) or neutral (N) wires to the earth pin marked
E or
Using an Extension Cable
• If an extension cable is required, use an approved triple
core extension cable suitable for the power input of
this tool (see technical data). The minimal conductor
size is 1.5mm2, the maximum length is 30m.
• When using a cable reel, always unwind the cable
completely.
WARNING:
115V units have to be operated via a fail-safe
isolating transformer with an earth screen
between the primary and secondary windings.
WARNING:
To reduce the risk of injury, read the instruction
manual.
VACUUM CLEANING SAFETY
Important Safety Instructions
WARNING!
Read all safety warnings and all instructions.
Failure to followthe warnings and instructions
may result in electric shock, fire and/or serious
injury.
SAVE ALL WARNINGS AND INSTRUCTIONS FOR
FUTURE REFERENCE.
BEFORE USING THE APPLIANCE, READ AND
FOLLOW ALL INSTRUCTIONS.
-6-
13 AMP
1
2