Panasonic EP-MAK1 Mode D'emploi page 47

(pour usage domestique) fauteuil vibromasseur
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Troubleshooting
Problem
Reclining does not take place
even though a massage is started.
(The seat does not automatically
recline.)
The backrest does not return to
the upright position.
The unit will not operate at all.
Touch panel is inoperable
It is not possible to massage
hands and arms.
Sometimes the power won't turn
on when
is pressed again
when a massage has finished.
Red, blue, or green pixels are
visible on the touch panel
The unit has been damaged.
The power cord or power plug is
abnormally hot.
(continued)
If the backrest has fallen over about 20 °, it does not recline
automatically.
If the unit is stopped by automatic shut-off or by pressing
not return automatically for safety.
→ To return from the reclined position to the original position, press
There is a power failure.
The power plug has been disconnected.
Power switch on the rear panel is set to "off".
The child lock has been applied.
Course selection or body part selection has not been made.
Touch panel may become inoperable due to interference from other
electronic devices in the vicinity.
→ Press the
button and turn off the power switch on the back of the
main unit. After about 10 seconds, turn the power back to "on" to operate.
Air plug may come loose from the air plug insertion port if the armrest
is not secured.
→ Check connection of the air plug and secure installation of the armrest.
Due to shutdown (approx. 5 seconds)
→ Wait at least 5 seconds once all movement has stopped before pressing
.
The child lock has been applied.
Defective pixels that do not light, remain continuously lit, appear non-
uniform, or experience color shifts are characteristic of touch screens
and considered normal.
→ To prevent accidents, be sure to contact an Panasonic service center.
Cause and Remedy
may not be accepted.
(EN43)
, it will
twice.
(EN13)
(EN18)
Air plug insertion port
Air plug
(EN14)
(EN18)
(EN53)
EN47

Publicité

Table des Matières
loading

Table des Matières