Explanation Of Functions - Becker Centronic UnitControl UC52 Notice De Montage Et D'utilisation

2. Put the protective caps back on the power supply unit.
3. Fit the power supply unit in the socket.
4. Place the control panel in the frame and insert this into the power supply
unit.

Explanation of functions

Manual/Automatic slide switch
In slide switch position " " only manual drive commands and alarm signals can
be performed (e.g.: UP, STOP, DOWN via button actuation).
In slide switch position " " automatic drive commands are performed
(control signals via group control inputs)
Alarm signal
An alarm signal (e.g. wind) is signalled by an illuminated indicator lamp. A con-
tinuous switching signal at the group or individual control inputs for longer
than 5 seconds is deemed an alarm signal.
The ALARM SIGNAL function can be switched on/off via the coding switch 1.
Group control unit
Several drives controlled simultaneously are referred to as a group.
RESET button
The intermediate position and ventilation/tilt position can be deleted by press-
ing the RESET button (with a ballpoint pen or similar object).
Intermediate position
The intermediate position is a freely selectable position of the roller shutter/
awning/blind between the upper and lower limit positions. Once programmed,
this position can be travelled to from the upper position.
To do so, press the DOWN button briefly twice in succession.
Ventilation/tilt
The ventilation/tilt position is a freely selectable position of the roller shutter/
blind between the lower and upper limit positions. This function allows you to
open the roller shutter from the lower limit position up until the ventilation slots
are opened. With the blind, the slats can be tilted.
To do so, press the UP button briefly twice in succession.
23 - en