KRESS 1400 HKS Mode D'emploi page 21

36727_a_BA_Handkreissäge_1400HKS.book Seite 21 Donnerstag, 20. Oktober 2011 9:25 09
Tools and accessories
Observe the specified conditions of use for the
saw: cutting wood or wood-like materials with
saw blades only. Grinding discs must not be
used.
Do not cut materials containing asbestos!
Sockets outdoors must be protected by
residual-current circuit breakers (FI-).
Never drill into the housing to mark the saw.
The protective insulation would be bridged.
Use stickers.
Motor
The strong universal motor has sufficient power
reserves. It is cooled by an extra-large fan unit.
-NOTE-
Prolonged heavy duty may overheat the motor!
Allow the motor to cool down at no-load
speed!
Work only with good, sharp saw blades. This
helps prevents the motor overheating!
5. Tools and accessories
Saw blades
Ø 190 mm, bore hole Ø 20 mm
hardened metal tipped, alternating tooth
Wood and wood-like materials, medium quality:
Number of teeth 14
Wood, wood-like materials and plastics, very
suitable for coated boards, clean-cutting:
Number of teeth 48
Sawing with the guide rail
The guide rail (25) helps you to perform straight
cuts. The adhesive coating prevents the guide rail
from slipping and protects the surface of the work-
piece. The coating on the guide rail allows the saw
to glide smoothly.
To saw at right angles, you can place the saw
directly on the guide rail (25). Attach the guide rail
(25) using suitable clamping devices, e.g. vices (27)
to the workpiece so that the narrow leg of the
guide rail (25) points towards the saw blade.
The guide rail (25) must not protrude beyond
the side of the workpiece which is to be sawn.
The guide rail adapter (28) is required for performing
bevel cuts with the guide rail (25). The guide rail
adapter (28) is fitted as shown in Figure 3.
Dust/chip suction
-NOTE-
Only operate the saw with a functioning dust/chip
extractor. The extractor must meet the require-
ments of the "Safety regulations for extraction and
removal of wood dust and shavings" (ZH1/139).
The extractor must ensure a minimum air speed of
20 m/s at the suction neck.
Dust from materials such as paints containing
lead, some types of wood, minerals and metal can
be health hazards. Contact with or breathing in such
dust can trigger allergic reactions and/or breathing
problems for the user and other persons in the
vicinity.
Certain dusts such as oak or beech dust are
classed as carcinogenic, especially in combination
with wood treatment additives (chromate, wood
preservatives).
We recommend the use of a dust extraction
device.
Ensure that the workplace is well ventilated.
Comply with the relevant regulations in place in
your country for the materials to be processed.
Use as a bench saw
The saw may only be used as a bench saw with
saw benches explicitly approved by their manu-
facturer for use with this KRESS saw.
Special accessories
Do not use accessories made by other manufac-
turers, as these are not tested by KRESS.
Using such accessories can be dangerous.
To prevent injury and damage, use only the
accessories and parts recommended by KRESS.
English 21
EN
1400HKS,1400DS-EN / 1106