KINZO 25C5030 Mode D'emploi page 47

Mounting an accessory (fig. A & B)
I Keep the spindle lock button (4) depressed.
Use the spanner (7) to slacken the collet nut (6).
I
Insert the shaft of the accessory into the collet.
I
Use the spanner to tighten the collet nut.
I
I Release the spindle lock button.
In order to remove the accessory, proceed in reverse order.
I
Using the flexible spindle (fig. C1 - C4 & D)
To mount the flexible spindle, proceed as follows:
I Keep the spindle lock button (4) depressed.
Loosen the collet nut (6).
I
Successively remove the collet nut (6) and the collar (5).
I
Remove the collet nut from the flexible spindle and fit it onto the tool.
I
I Insert the end of the flexible spindle into the collet nut.
Tighten the collet nut.
I
Release the spindle lock button.
I
Fit the collar of the flexible spindle onto the tool. Tighten the collar.
I
I Fit the collet nut (6) onto the flexible spindle.
To mount an accessory, proceed as follows:
Position the key (8) in the recess to fix the collet.
I
I Loosen the collet nut (6).
Insert the shaft of the accessory into the collet.
I
Tighten the collet nut.
I
Remove the key.
I
I In order to remove the accessory, proceed in reverse order.
Replacing the collet (fig. A & B)
Keep the spindle lock button (4) depressed.
I
Use the spanner (7) to slacken the collet nut (6).
I
25C5030
25C5030_20.p7
Before mounting an accessory, always unplug the tool.
Before mounting an accessory, always unplug the tool.
47
47
04-06-2004, 15:29