Skytec ST-1000 Mode D'emploi page 19

- When you unplug the unit from the mains always pull the
plug, never the lead.
- In order to prevent dropping of the unit, a safety fastening
needs to be installed. This can be a solid chain, a steel cable,
etc. which has to be fastened separately from the mounting
bracket.
- The supplied bracket is the main fixing and must be used to
solidly mount the light effect.
- In order to avoid accidents in public premises, the local legal
requirements and safety regulations/warnings must be
fulfilled.
- Keep out of the reach of children.
Safety Instructions
The smoke machine must only be connected to an earthed outlet !
For indoor use only. Place the unit in a dry location. ATTENTION: the
powercord can only be replaced with a replacement supplied by
SkyTronic!
Set up
Choose a horizontal location where the smoke machine can easily be
refilled. Make sure that the smoke coming directly out of the machine,
can never get into contact with people. The smoke is very hot. Please
keep a 1m safety distance.
Be extremely careful when filling the tank. First of all, unplug the unit
from the mains ! Open the tank and fill it by means of a funnel.
Remove eventually spilled smoke fluid before you switch the unit on.
Only use original SkyTronic smoke fluid. This fluid is environmental
friendly, biodegradable and leaves no residues, if used properly.
Never obstruct the openings on the top of the case. The heating
element of the smoke generator develops heat that must be
dissipated. Do not place any objects on the smoke machine.