Get Started - Silk-n Fresh Mode D'emploi

6.

Get started!

Select the brush head suitable for your skin type.
1.
Gently push the brush head onto the nipple
which sits on top of the brush attachment
point, until you hear a click.
Make sure that the nipple covers the metal
Z
attachment point before you start your
treatment. This will prevent it from touching or
irritating your skin.
Pour the face wash into the dispenser (see section 4.3 What types of face
2.
wash can I use?, and section 4.4 Adding liquid face wash).
3. Dampen your face with lukewarm water.
Moisten the brush head with lukewarm water. Do not use a dry brush
4.
head on the face or neck, because it may cause skin irritation.
Press the control button to turn on the device. The device automatically
5.
starts in the low speed vibration mode.
To select the mode you want, keep pressing the control button to cycle
6.
through the modes (see section 4.2 Indicator lights and function settings).
7. To release face wash, hold the device in an upright position and press the
dispensing button once, then release. It may take a second or so before
the dispenser releases the face wash. The device will release face wash for
about 3 seconds. If you need more, press the dispensing button again.
For first time use, press the dispensing button a few times until face wash
Z
is released.
Gently press the brush head against your skin and move it in an upward
8.
circular motion. There's no need to apply any pressure.
Z
Try to avoid delicate skin areas such as around the eyes or lips.
9. To finish, rinse your skin with water, and pat dry with a towel.
The device is set to switch off automatically after 1 minute. However, if you
Z
change modes during a treatment, the timer will reset to zero and will start
again.
11
EN