Sharp LL-T2000A Mode D'emploi page 21

MENU 1: ADJUSTMENT
MANUAL: Individual menu options are manually
adjusted.
AUTO: Every menu option is automatically
adjusted
Notes:
- Press the
- To choose a menu option:
- To go to MENU 2:
CLOCK
The figure below demonstrates how to adjust so that
vertical flicker noise is not emitted. (
PHASE
The figure below demonstrates how to adjust so that
horizontal flicker noise is not emitted. (
Note:
- Adjustments to PHASE should be made only
after CLOCK has been correctly set.
H-POS (horizontal positioning) and V-POS
(vertical positioning)
To center the screen image within the boundaries of
the screen, adjust the left-right (H-POS) values and
the up-down (V-POS) values. (
Downloaded from: http://www.usersmanualguide.com/
Adjusting the screen display
button to select AUTO.
SELECT button
MENU button
Vertical flicker noise
Horizontal flicker noise
buttons)
Screen frame
MENU 2: GAIN CONTROL
MANUAL: Individual menu options are manually
AUTO:
Notes:
- Press the
- To choose a menu option:
- To go to MENU 3:
buttons)
*Auto Gain Control function
The Auto Gain Control adjusts contrast and
brightness based on the brightest color of the
image displayed. If you are not using the
Adjustment Pattern it is necessary to have an
area of at least 5 mm x 5 mm of white image
displayed, and if not adjustments may not be
possible. (In such case, [OUT OF ADJUST] will
appear and setting values remain unchanged.)
buttons)
BRIGHT (brightness)
Total screen brightness can be adjusted while
watching the color pattern. (
CONT (Contrast)
While watching the color pattern, adjustments can be
made so that all graduations appear. (
21
adjusted.
Every menu option is automatically
adjusted using the Auto Gain Control*
function,
button to select AUTO.
SELECT button
MENU button
buttons)
Color pattern
buttons)