Important Safety Instructions; Dimensions - CHIEF CPA262 Instructions D'installation

DISCLAIMER
Milestone AV Technologies and its affiliated corporations and
subsidiaries (collectively "Milestone"), intend to make this
manual accurate and complete. However, Milestone makes no
claim that the information contained herein covers all details,
conditions or variations, nor does it provide for every possible
contingency in connection with the installation or use of this
product. The information contained in this document is subject
to change without notice or obligation of any kind. Milestone
makes no representation of warranty, expressed or implied,
regarding the information contained herein. Milestone assumes
no responsibility for accuracy, completeness or sufficiency of
the information contained in this document.
Chief® is a registered trademark of Milestone AV Technologies.
All rights reserved.
DEFINITIONS
WARNING:
A WARNING alerts you to the possibility of
serious injury or death if you do not follow the instructions.
CAUTION:
A CAUTION alerts you to the possibility of
damage or destruction of equipment if you do not follow the
corresponding instructions.
MOUNTING SYSTEM:
primary product designed by Chief® to mount the projector or
display.
ACCESSORY:
An ACCESSORY is any product designed by
Chief® to complement the primary mounting system either by
mounting any supporting components or enhancing the
mounting capabilities of the primary mounting system.
COMPONENT:
A COMPONENT is any secondary product to
be mounted to an accessory, i.e. speakers, CPU's, cameras,
tablets, additional displays.

IMPORTANT SAFETY INSTRUCTIONS

WARNING:
Failure to read, thoroughly understand, and
follow all instructions can result in serious personal injury,
damage to equipment, or voiding of factory warranty! It is the
installer's responsibility to make sure all mounting systems/

DIMENSIONS

2
A MOUNTING SYSTEM is the
0.34
8.6
accessories are properly assembled and installed using the
instructions provided.
WARNING:
Failure to provide adequate structural strength
for this accessory can result in serious personal injury or
damage to equipment! It is the installer's responsibility to
make sure the structure to which this accessory is attached
can support five times the combined weight of all equipment.
Reinforce the structure as required before installing the
accessory.
WARNING:
Exceeding the weight capacity can result in
serious personal injury or damage to equipment! It is the
installer's responsibility to make sure the combined weight of
all components located within the mounting system of the
CPA262 does not exceed 500 lbs (226.8 kg).
• The weight capacity of the CPA262 may be LIMITED to
the lowest weight capacity of any other component or
accessory used within the mounting system.
WARNING:
Use this accessory only for its intended use as
described in these instructions. Do not use attachments not
recommended by the manufacturer.
WARNING:
Never operate this accessory if it is damaged.
Return the accessory to a service center for examination and
repair.
WARNING:
Do not use this product outdoors.
NOTE:
Accessory is intended to be used with the UL Listed
CPA Extension Column Series and a 1-1/2" NPT or
NPSM following ANSI/ASME B1.20.1 (Schedule 40,
0.154" minimum thickness aluminum-ASTM B221)
threaded extension column (not included).
--SAVE THESE INSTRUCTIONS--
4.25
108.0
0.38
9.5
2.88
73.2
Installation Instructions
2.25
57.2