GEZE Slimdrive SD Instructions De Montage page 10

Zwischenhaube, Datei SD_ZH_A.p65
Electric connections:
Cable connection Slimdrive SD moving leaf / fixed leaf
To simultaneously trigger the two Slimdrive SD by all commonly used trigger elements
connect the multi-pole cable ( 8 x 0.25 mm
between the two drives.
(See also mounting instruction Slimdrive SD , chapter 6.5)
1 st Closing leaf:
a)
2 nd Closing leaf:
b)
NOTE:
Programme switch and latch
switching contact can be
connected to the
2 nd closing leaf only.
10
Alter drive delay.
For this purpose switch off mains supply and remove cover of control.
Plug jumper JP 1 onto 2-3 (see illustration).
Jumper JP1
Remove jumpers 5/6 and 7/8 (marked a in wiring diagram below) on terminal
block of 1 closing leaf drive control.
st
To switch off this drive separately: Remove jumper 6-7 and connect ON/OFF
switch.
(Leave drive delay in pre-set position, Jumper JP1 to position 1-2)
To switch off the two drives simultaneously with an ON/OFF switch remove
jumper b) at terminal 6-7 of the 2
If a programme switch or latch switching contact is connected, the
corresponding jumpers on the terminal block 8 of the 2
removed.
2 ) (supplied) to terminals
Control, cover removed
closing leaf and connect an ON/OFF switch.
nd
Terminal boards
2 nd closing leaf
and
clsoing leaf must be
nd
1 st closing leaf