Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
• Quality management for testing every production charge
Besides the motor and the chain, you need two chains for mirrorballs up to 100 cm certified, 100 cm, No.
50301616 and three screw-on carabines 8 mm for mirrorballs up to 100 cm, No. 50301634 for the
installation.
Overview
1
2
3
4
5
6
INSTALLATION
Please consider the EN 60598-2-17 and the respective national norms during the
installation! The installation must only be carried out by an authorized dealer!
The installation of the mirrorball has to be built and constructed in a way that it can hold 10 times the weight
for 1 hour without any harming deformation.
The installation must always be secured with a secondary safety attachment. This secondary safety attach-
ment must be constructed in a way that no part of the installation can fall down if the main attachment fails.
When rigging, derigging or servicing the fixture staying in the area below the installation place, on bridges,
under high working places and other endangered areas is forbidden.
The operator has to make sure that safety-relating and machine-technical installations are approved by an
expert before taking into operation for the first time and after changes before taking into operation another
time.
7
(1) Mirrorball motor
(2) Motor axle
(3) Screw-on chain link
(4) Mirrorball chain
(5) Installation eyelet
8
(6) Mirrorball
(7) Safety eyelet
9
(8) Safety chain
(9) Safety eyelet
DANGER TO LIFE!
13/29
50301510_V_1_1.DOC
Publicité
Table des Matières
