T&S B-0850 Série Instructions D'installation Et D'entretien page 5

General Instructions
6. Remove no.13, no.14 and no.15
from no.16. Assemble the previous
items onto arm of no.7, as shown in
illustration below. Both side valves.
16
13,14,15
7. Insert no.7 into no.16, loosely
tighten no.13 onto threads by hand.
Do this for both hot and cold valves.
4 (grooves
16
should face
downward)
7
13
Hot Side
4
(grooves should
face upward)
8. Insert no.16 up through underside
of sink or lavatory and fi t no.4 onto
no.12. (Make sure greased no.6 is in
place.)
9. Loosely tighten no.17 and no.18
against bottom of sink. Do this for
both sides.
16
18
17
10. Reinstall no.19 and no.20 onto
no.16 at top of sink. Loosely tighten
by hand. Do this for both sides.
(Make sure greased no.8 is in place.)
7
Final Assembly of Center Body
(No.12) Section:
11. Reinstall second no.6, no.3, no.5
and no.2 onto no.12. Make necessary
adjustments to allow proper position-
ing of no.1.
1
3
Cold Side
12. Tighten no.10 and (top) no.11
12
on underside of lavatory sink with a
wrench.
13. Tighten no.2 on bottom of no.12
with a wrench.
6
14. Tighten no.17 and no.18 on both
4
no.16's underneath lavatory sink, also
tighten no.19 and no.20 on top side of
lavatory sink, with a wrench.
5
16
20
19
6
8
4
12
6
5
2
12
.85 to .88
10
11
9
13
2