Switch Off; Motor Protection; Dust/Chip Exhaustion; Adjusting The Saw - ATIKA BMS 250 Instructions D'utilisation

On / Off Switch
Do not use any device where the switch can not be
switched on and off. Damaged switches must be repaired
or replaced immediately by the customer service.
Switch on
Press the green button ( I )
on the switch.
If there is a power cut, the
machine switches
automatically. To switch on
again, press the green ( I )
button.

Switch off

Press the red button ( 0 ) on the switch.

Motor protection

The motor is equipped with a safety switch and
switches off independently when overloaded.
It can be switched back on following cooling phase (5 -
10 min.) .
First press
1. the red button (0)
2. the small button with the clear cover (15)
3. the green button ( I ) to start

Dust/chip exhaustion

The wood dust generated during operation impedes the
necessary view and is harmful to health to some degree.
If the machine is not used in the open air, a shavings exhausts
must be attached to both exhaust outlets (e.g. small
transportable dust remover).
Chip exhaustion
Connect a chip exhaust system or small vacuum cleaner
with suitable adapter to the chip exhaust neck (26) (Ø 35 mm).
Air velocity at the exhaust neck of the saw ≥ 20 m/sec
Use a special exhaust device when exhausting dusts that are
especially harmful to health, carcinogen or dry.

Adjusting the saw

Pull the mains plug before performing
settings.
off

Splitting wedge setting

The splitting wedge is an important safety device as it prevents
the workpiece from recoiling
To guarantee the function of the splitting wedge, its distance
from the toothed wheel its distance from the teeth of the saw
blade above the table must not be more than 5 mm.
Set the cutting height
The cut height
can be adjusted
stepless from 0
- 75 mm using
the crank (11).
Before setting
the cut height,
tighten the set
screw for the
saw blade (13).
Set the cutting
height 5 mm
higher than the
material
thickness.
Adjust saw blade pitch
The saw blade must not be set to the inclined position
when the blade is turning. The motor must be switched
off first.
Adjusting between 0° - 45°
1. Loosen the
clamping screw
(13).
2. Turn the
handwheel until
the required angle
is shown (0° -
45°).
3. Retighten the set
screw.
Adjusting the angle indicator:
1. Turn the machine off and unplug the power cord.
2. Use an angle stop to align the saw blade vertically.
3. Loosen the screw (A) and slide the angle indicator to the 0°
mark.
22