Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Installation Instructions
Installing to a Solid Concrete Ceiling Structure
WARNING:
The CPA116 is designed to be mounted to a
concrete ceiling with a minimum thickness of 8" and a
maximum drywall covering of 5/8" (1.6cm).
WARNING:
Fischer UX10 or AF8 anchors (not included)
must be installed into structurally sound solid concrete.
Installation into hollow concrete block, mortar, or concrete
that exhibits cracking, spalling, or other defects may result in
failure of anchor and serious personal injury or damage to
equipment.
1.
Using ceiling plate (A) as a template, mark locations of four
pilot holes on ceiling.
2.
Drill pilot holes at marked locations. If using UX10 anchors,
pilot hole diameter will be 3/8". If using AF8 anchors, pilot
hole diameter will be 5/16".
3.
Install four UX10 or AF8 anchors into four drilled holes. (See
Figure 7)
4.
Loosely install two 5/16" x 2 3/4" bolts (not provided)
through two 5/16" flat washers (not provided) into opposite
anchors. (See Figure 7)
5.
Place ceiling plate (A) up to ceiling and turn until bolts hold
plate up in position. (See Figure 7)
3
UX10 or AF8 anchors (not included) x 4
washers x 2
5
Figure 7
6.
Install two 5/16" x 2 3/4" bolts (not included) through two
5/16" flat washers (not included) through holes on ceiling
plate (A) and into anchors. (See Figure 8)
7.
Tighten all four bolts to secure plate to ceiling. (See Figure
8)
washers x 2
Installing Ceiling Plate Cover
1.
2.
3.
(Rear view)
x 2
4
5
4.
x 2
6
Figure 8
Maneuver ceiling plate cover (B) so that it is able to wrap
around extension column. (See Figure 9)
Wrap ceiling plate cover (B) around extension column. (See
Figure 9)
Use two M6 x 6mm button head cap screws (E) to secure
ceiling plate cover (B) to CPA116 plate (A). (See Figure 9)
2
3
Figure 9
Complete installation following column extension
installation instructions.
CPA116
x 4
7
1
1
(E) x 2
7
Publicité
Table des Matières
