CHIEF CPA116 Instructions D'utilisation page 6

CPA116
3. Loosely install two 5/16" x 2-3/4" (minimum) lag screws (not
included) through two 5/16" washers (not included) into
opposite corners of holes drilled in wood stud cross bracing.
(See Figure 4)
4. Place ceiling plate (A) up to ceiling and turn until lag screws
hold plate up in position. (See Figure 4)
4
(A)
3
Figure 4
5. Install two 5/16" x 2-3/4" (minimum) lag screws (not
included) through holes on ceiling plate (A) and into holes
drilled in wood stud cross bracing. (See Figure 5)
6. Tighten all four lag screws to secure plate to ceiling. (See
Figure 5)
Figure 5
6
4
washers x 2
x 2
x 4
6
x 2
5
Installing to a Suspended Ceiling
NOTE:
The CPA mount may be suspended from four 3/8 in.
diameter threaded rods (not included) which are
secured to a 1-5/8" x 1-5/8" 12ga metal framing strut
channel (spanning a maximum of 4 feet--not provided)
by 3/8" channel nuts (not included). Threaded rods
must have 16 threads per square inch.
1. Insert the rods into the four bolt holes in the CPA mount.
2. Secure the threaded rods to the CPA mount with 3/8" jam
nuts (not included) and washers (one of each on inside and
one of each on outside-not provided). (See Figure 6)
Figure 6
Installation Instructions
1
Secure to unistrut
using channel nuts
(not included).
Secure to angle or
channel assembly
using jam nuts
(not included).
Threaded
rods
(A)
Secure with jam
nuts and washers
2
(not included)