Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Installation Instructions
INSTALLATION
IMPORTANT ! : The CPA116 must be attached to the
extension column prior to attaching ceiling plate to the
ceiling!
Attaching to Ceiling Column
1.
Place extension column (not included) over CPA116 (A) pin
connector, lining up holes on pipe with holes in pin. (See
Figure 1)
2.
Use two M6 x 16mm button head cap screws (C) or two M6
x 16mm button head security screws (D), two M6 lock
washers (F) and two M6 flat washers (G) to secure
extension column to connector pin. (See Figure 1)
(A)
1
(G) x 2
(F) x 2
Figure 1
3.
Tighten screw on top of CPA116 plate to fully secure plate
to connector pin. (See Figure 2)
IMPORTANT ! : To ensure a secure connection, make
sure metal tabs are clearly visible after tightening bolt.
(See Figure 2)
Figure 2
2
(C) or (D) x 2
3
metal tabs x 2
Connecting to Ceiling
These CPA mounts are designed for attachment to a double 2"
x 4" wood framework ceiling, a concrete ceiling or a suspended
metal framing channel ceiling.
WARNING:
Do NOT attach to vertical mounting surfaces
such as walls or angled ceilings!
WARNING:
IMPROPER INSTALLATION CAN LEAD TO
LIFT FALLING CAUSING SEVERE PERSONAL INJURY OR
DAMAGE TO EQUIPMENT! It is the installer's responsibility
to make certain the structure to which the mount is being
attached is capable of supporting five times the weight of the
CPA mount and all attached equipment. Reinforce the
structure as required before installing the mount.
NOTE:
The following instructions assume a suitable mounting
structure and surface exists prior to installation.
Installing to a Wood Framework (Joists)
IMPORTANT ! :
The CPA116 is designed to be mounted to
double 2" x 4" wood stud cross bracing (5" on center) between
two ceiling joists with a maximum drywall covering of 5/8".
1.
Using ceiling plate (A) as a template, mark locations of four
pilot holes (See Figure 3). Ensure the marks are in the
center of wood joists.
1
x 4
2
Cross bracing
Figure 3
2.
Drill 7/32" diameter pilot holes into wood stud cross bracing.
(See Figure 3) Ensure pilot holes are straight.
CPA116
5
Publicité
Table des Matières
