Using Asio Direct Monitor - Roland Edirol UR-80 Mode D'emploi

Using ASIO Direct Monitor

If you are using the UR-80 from an ASIO 2.0 compatible application, the UR-80's Input Monitor
select switch can be controlled from your ASIO 2.0 compatible application.
1. As described in Opening the driver settings dialog box, open the "Driver Settings" dialog
box.
2. Make the following settings.
Check the "Use ASIO Direct Monitor" check box.
3. Click [OK] to close the driver settings dialog box.
* Depending on your application, there may also be an ASIO Direct Monitor setting among the audio
settings of your application. For details, refer to the operation manual for your application.
* When using ASIO Direct Monitor, monitoring may switch on/off at unexpected times, depending on the
application settings and on the recording procedure. If this occurs, uncheck the check box in step 2
to disable ASIO Direct Monitor.
Opening the driver settings dialog box
If using Windows:
1. Open the "Control Panel" and double-click "EDIROL UR-80".
2. The "EDIROL UR-80 Driver Settings" dialog box will appear.
* In Windows XP, click "Switch to classic view" to switch the display to the classic view. EDIROL UR-
80 will not be displayed unless the classic view is selected.
* In Windows Me, click "View all Control Panel options."
If using Macintosh:
Open the ASIO Control Panel from the Audio Settings dialog box of your ASIO-compatible
application. The name of the Audio Settings dialog box and the procedure for opening the ASIO
Control Panel will differ depending on your application. For details, refer to the operation manual
for your application.
Recording audio
65